ION L4-2.2L VIN F (2004)
5. Remove the lower control arm ball stud to steering knuckle pinch bolt and nut.
6. Lower the lower control arm to separate the ball stud from the steering knuckle. If necessary, use the J 4363 1.
7. Remove the strut to steering knuckle nuts and bolts.
8. Remove the steering knuckle from the vehicle.
Installation Procedure
1. Position the steering knuckle onto the lower control arm ball stud, while guiding the axle through the knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the strut to knuckle bolts and nuts.
-
Tighten the bolts and nuts to 120 Nm (89 ft. lbs.).