ION L4-2.2L VIN F (2004)
10. Install the fluid temperature sensor clamp (49).
11. Install the fluid temperature sensor bolt (31).
^
Tighten the bolt to 10 Nm (89 inch lbs.)
12. Connect the solenoid harness connectors in the following order:
12.1.
Blue (1)
12.2.
Black (2)
12.3.
Green (3)
12.4.
Black (4)
12.5.
Blue (5)
12.6.
Gray (6)
12.7.
Green (7)
12.8.
Gray (8)
Important: The cover and transaxle must be free of dirt, gasket material and debris in order to seal properly.
13. Clean and inspect the valve body cover and transaxle gasket surfaces for gasket material and debris.