ION L4-2.4L (2007)
4. The knob can be removed by screwing a self-threading plate screw with a flat tip (25 x 5.5 mm) into the hole.
5. Remove the shifter knob (3) from the shiftier spline (2) and shifter assembly (1).
Installation Procedure
Important: Use adhesive Loctite(TM) 270 with Activator 7471 or Activator 7649. DO NOT operate the lever until the adhesive has dried
(approximately 30 minutes).
1. Apply adhesive to the knob.
2. Seat the shifter knob over the shifter lever. Ensure the spring and foam rings are correctly seated.
3. Position and fit the emblem over the shifter knob.
4. Vacuum and clean any debris.
Shift Control Assembly Replacement
Shift Control Assembly Replacement
Removal Procedure
1. Remove the console top cover.
2. Remove the shift cables from the shifter assembly.