L200 L4-2.2L VIN F (2002)
25. Install temperature door cable eyelet over temperature door lever. Do not install housing into retaining clip at this time.
26. Attach electrical harness to back of module. Connect actuators, blower resistor, and route to blower motor.
Automatic Climate Control Vehicles Only:
27. Attach electrical harness to back of module. Connect actuators, blower control module and route to blower motor.
28. Push blower motor harness grommet through hole then pull back to seat.
29. Install harness to case screw at mode actuator.
30. Install blower motor assembly into module housing. Blower motor assembly rib must fit into channel in housing.
31. Connect blower motor electrical connector.