L300 V6-3.0L VIN R (2001)
1. Remove old urethane with a razor knife leaving a thin film (approximately 1-2 mm [0.04-0.08 in.]) around the perimeter of window opening and
window assembly (if being reused).
2. Clean the entire window opening and glass bonding surfaces with a clean lint-free, alcohol dampened cloth. Allow to air dry.
3. Install molding around perimeter of glass.
IMPORTANT: If applied molding becomes loose from edge of glass, clear and black prime affected area, allow to air dry. Apply a thin bead of
urethane and install molding.
4. Replace molding if damaged or excessively stretched.
NOTE: To prevent corrosion, paint damage around the window opening by the power glass removal tool must be covered with pinchweld primer.
Do not prime over existing urethane. Follow manufacturer's recommendations for drying time.
5. New window assembly only -
Shake glass prep primer (Clear #1) well before using. Apply glass prep primer (Clear #1) around entire perimeter of glass using dauber. Wipe dry
with a clean lint-free cloth
Primer area (Minimum Width, A): 18 mm (0.71 in.)
Shake glass primer (Black #2) well before applying. With a new dauber apply glass prep primer (Black #2) around the entire perimeter over Clear
#1. Allow primer to dry five minutes before applying urethane.
Primer area (Minimum Width, A): 18 mm (0.71 in.)
6. Apply a smooth continuous bead of adhesive directly to old urethane adhesive in glass opening or to glass. Apply according to dimensions shown.
