L Series V6-3.0L VIN R (2004)
1. Lower the vehicle.
2. Install the oil feed and install the return lines to the engine oil cooler. Use 4 new seals.
^
Tighten the oiler cooler feed and return lines to engine block to 30 Nm (22 ft. lbs.).
3. Install the engine oil cooler line clamp.
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist,
provide additional support for the vehicle on the opposite end from which the components are being removed.
4. Raise and support the vehicle.
5. Install the oil feed line to the engine block.
^
Tighten the oil cooler feed and return lines to engine block to 30 Nm (22 ft. lbs.).
6. Install the return line to the engine block.
^
Tighten the oil cooler feed and return lines to engine block to 30 Nm (22 ft. lbs.).