L Series V6-3.0L VIN R (2004)
8. Remove the throttle body nuts.
9. Remove the throttle body.
INSTALLATION PROCEDURE
Throttle Body Relearn Procedure
IMPORTANT: Upon replacement of a new throttle body, the Throttle Body Relearn procedure must be performed.
-
Turn the ignition OFF for 10 seconds.
-
Turn the Ignition ON with the engine OFF.
-
Make sure these engine operating parameters are met before proceeding:
-
The ECT is between 6-100°C (43-212°F).
-
The IAT is greater than 6°C (43°F).
-
The ignition voltage is above 10 volts.
-
The accelerator pedal angle is less than 14 percent.
-
Leave the ignition ON for 1 minute with the engine OFF.
1. Install the throttle body and new gasket.