L Series V6-3.0L VIN R (2004)
6. Install the belt tensioner and the attachment bolts.
Tighten the belt tensioner bolts to 40 N.m (30 lb ft).
7. Install the front splash shield, pushpins, and screws.
8. Lower the vehicle.
9. Tighten the upper generator to the engine block bolt, if not already tightened.
Tighten the generator mounting bolts to 40 N.m (30 lb ft).
10. Connect the knock sensor 1 harness connector. Push the connector in until the lock position is felt, the pull back to confirm engagement.
11. Install the drive belt.
12. Connect the negative battery cable to the battery.
Tighten the battery terminal bolts to 17 N.m (13 lb ft).
13. Reprogram the preset radio stations and set the clock to the correct time.