LW2 V6-3.0L VIN R (2000)
Tighten the rear shoulder belt upper fasteners to 35 N.m (26 lb/ft)
5. Snap the upper shoulder belt fastener cover into place.
6. Raise the rear seat back assembly.
7. Apply the weatherstrip over the front and rear of the side molding using a flat-blade tool.
8. Install the cargo shade.
9. Function the shoulder belt assembly to assure the proper operation.
Panel Assembly - Quarter Inner Rear Replacement
Panel Assembly - Quarter Inner Rear Replacement
Important: Some parts have structural weld-thru adhesive in the joint areas. It is necessary to replace this with additional spot welds at
the attachment points. This can be accomplished by adding an additional weld between each factory weld in all areas.
1. Note amount and location of spot welds.
2. Remove sealer and drill spot welds from:
1. Panel assembly rear compartment front
2. Rail assembly rear compartment rear
3. Panel assembly rocker inner
4. Rail assembly rear compartment longitudinal
