LW2 V6-3.0L VIN R (2000)
5. Panel assembly quarter inner lower rear
6. Panel assembly rear side door ring outer
7. Panel assembly rear seat to back window (Sedan)
3. Clean all weld seams with a wire brush. Prime and seal all repair areas.
4. Apply permanent underbody sealant.
Important: Ensure that proper corrosion protection processes are used on all repair areas.
5. Prime with two-part catalyzed primer.
6. Apply sealers and corrosion protection materials according to information in the "Body Paint" section of this service manual or paint
manufacturer's recommendations.
7. Clean surface for welding and grind primer off new part at connecting points. Apply 3M(R) Weld-Thru Coating P/N 05913 (or equivalent) to all
areas to be welded, apply structural adhesive to fuel fill tube pocket.
Important: For Wagon, it will be necessary to install rear trim attach brackets.
8. Measure and align. Clamp in place.
9. Use MIG to plug weld.
Rear Compartment Closeout Panel Replacement
Rear Compartment Closeout Panel Replacement
Removal Procedure
1. Flip the load floor side-wings upwards.
2. Lift the load floor upwards.
3. Slide the load floor tabs out of the front load floor assembly.
4. Lift the load floor out of the vehicle.
Installation Procedure