LW2 V6-3.0L VIN R (2000)
NOTICE:
Since rear camber will now be adjustable, and toe and camber setting impact each other, the following order of adjustment must be followed.
1.
Rear camber initial set
2.
Rear toe initial set
3.
Rear camber final set
4.
Rear toe final set
5.
Right front camber
6.
Left front camber
7.
Front toe
IMPORTANT:
When measuring alignment angles, it is critical that the vehicle bumper height be correct. Measure and adjust bumper height according to the
following procedure before performing alignment.
1.
Place vehicle on a level surface.
2.
Adjust tire pressure to correct specifications.
Curb bumper height should be measured with:
^
207 kPa (30 psi) tire pressure front tires
^
207 kPa (30 psi) tire pressure rear tires
3.
If vehicle fuel tank is not full, the chart shown may be used to determine amount of weight necessary to be added to the trunk of vehicle to
simulate a full fuel tank.
4.
Bounce front and rear of vehicle a few times to settle suspension.
