SL L4-1.9L SOHC VIN 8 (1997)
CAUTION: After the front cover is installed, 6 to 12 squirts of oil can be pumped through the front oil seal drain back hole to make sure it is not
plugged to prevent front seal damage.
6. Install water pump pulley, if removed: Torque to 25 Nm (19 ft. lbs.)
CAUTION: Install a thin film of RTV sealant P/N 21006236 between the damper/pulley assembly flange and washer only. The washer and bolt
head flange are designed to prevent oil leakage and do not require sealant.
7. Remove the crankshaft timing gear retaining tool and install crankshaft pulley and retaining bolt/washer. Hold pulley with a strap wrench or use a
3/4 in square x 12 in long piece of wood wedged between the pulley spoke and rear, lower side of cover when removing the bolt. Torque to 215
Nm (159 ft. lbs.).
8. Apply RTV across the cylinder head and front cover T-joints. The rocker cover gasket can be reused if not damaged. Install rocker cover assembly
