SW L4-1.9L DOHC VIN 7 (1993)
Torque: 30 N.m (22 ft-lbs)
4. Install pulley on pump hub. The pulley can be held using a strap wrench, block of wood or hammer handle.
Torque: 25 N.m (19 ft-lbs)
IMPORTANT: If the pump pulley hub end extending through the pulley is rusty, clean it with a wire brush and apply a thin coat of primer paint to
prevent the pulley from rusting on the hub.
5. Install accessory drive belt. (Reference "Engine Drive Belt" and "Accessories".) See: Engine/Drive Belts, Mounts, Brackets and Accessories
6. Install right hand splash shield and tire.
7. Close radiator drain plug and install cylinder block drain plug.
Cylinder block drain plug Torque: 35 No.m (26 ft-lbs)
NOTICE: The vehicle must be level when filing with coolant.
8. Remove pressure cap and fill the system with coolant. Use only a non phosphate ethylene glycol-base coolant, mixed according to the
manufacturer's directions. See:
9. Start engine.
10. Fill the cooling system surge tank to the FULL COLD line after engine has run two to three minutes. Install pressure cap and check for leaks.