SW1 L4-1.9L SOHC VIN 8 (1996)
5. Install outer sealing strip by aligning location tab at rear of sealing strip with slot in door panel. Working from the rear forward, push seal strip
down onto flange until fully seated. Install retaining screw.
6. Check seal on mirror assembly for proper location and install mirror assembly to door. Install nuts and tighten.
Torque: 6 N.m (53 in-lbs)
7. If equipped with passenger side power mirror, connect harness connector and install connector position assurance (CPA) device.
8. Install foam filler in mirror patch area.
9. On driver's side, install mirror cable into trim panel and tighten set screw.
