SW1 L4-1.9L SOHC VIN 8 (1996)
5.
For Sedans, remove the rectangle shaped heat stakes with a hand grinder (die grinder) with 38 mm (1-1/4 in.) diameter grinding disk, or
equivalent, by grinding the studs from the side.
6.
Remove the old door insert from the door trim panel.
(Sedan panel shown, Coupe panel similar)
7.
Remove any heat stake material that may be left in the door trim panel holes, or on the door trim panel substrate.
(Sedan panel shown, Coupe panel similar)
Front Interior Door Trim Panel/Installation
1.
Center the new door insert on the door trim panel.
(Sedan panel shown, Coupe panel similar)
2.
Place the door trim panel assembly back on the cloth-type protective material with the heat-stake side up.