SW1 L4-1.9L SOHC VIN 8 (1996)
b. For Sedans, use grinder or wire cutter and carefully remove 2 mm (5/64 in.) of length from latch end of existing lock cylinder rod.
IMPORTANT:
Vehicles equipped with or without the remote keyless entry (RKE) feature use the same trap-resistant latch that is included in the kit. This latch will
function properly on all vehicles.
14.
Reconnect vehicle interior release cable end fitting into lower slot of new trap-resistant latch, and clip cable conduit to latch housing.
15.
Insert release handle cable end fitting into upper slot of new trap-resistant latch, and clip cable conduit to latch housing.
IMPORTANT:
All 1996 and some early 1997 vehicles were equipped with a ring terminal ground connector that must be installed between decklid and latch prior to
installing latch.
16.
Install trap-resistant latch-to-decklid retaining bolts.
