SW1 L4-1.9L SOHC VIN 8 (1996)
27.
Mark a position on decklid inner panel that will allow cable clip to fully seat in decklid sheet metal. Position release handle cable clip as close as
possible to center of cable.
NOTICE: If drill hit is allowed to drill into sheet metal at a depth greater than 6.5 mm (1/4 in.), outer surface of exterior panel may be penetrated.
28.
Center-punch and drill 6.5 mm (1/4 in.) hole at mark on inner panel.
29.
Apply 3M(R) WINDO-WELD Primer (P/N 08643) or equivalent to bare metal edges of hole.
30.
Install release handle cable and cable clip to decklid.
1996-1999 Coupe and Sedan
1.
Wrap entire length of handle wiring harness with tape to prevent damage to wires.
2.
Route handle wires along existing decklid harness over to bottom of decklid hinge.
3.
Insert handle wires into existing clips along decklid harness.
