SW1 L4-1.9L SOHC VIN 8 (1996)
4.
Place handle ORN wire in approximately three feet of conduit (P/N 21023494) and route it through holes in the bottom of rear window panel over
to the cargo lamp.
5.
Remove cargo lamp housing and disconnect cargo lamp if needed.
6.
Splice handle ORN wire to cargo lamp ORN wire, circuit 340, using splice sleeves supplied with kit.
7.
Tape wire to prevent damage due to sharp metal edges.
8.
Cut to length and splice handle WHT wire to vehicle RED/BLK wire, circuit 744, using splice sleeves supplied with kit. The vehicle RED/BLK
wire can be found at decklid in-line connector near base of decklid hinge and will be located in one of the following cavities:
^
Cavity F on SL vehicles
^
Cavity H on 1997-1999 SC vehicles
^
Cavity D on 1996 SC vehicles
