SW1 L4-1.9L SOHC VIN 8 (1996)
8.
Fasten a rivet nut onto installation tool (both included in kit).
9.
Place installation tool with rivet nut into hole in rear window panel.
10.
Use a wrench to hold installation tool nut. Tighten installation tool bolt until rivet nut is collapsed and will not rotate in hole.
11.
Remove masking tape from seal backs and install rivet nuts in remaining rear window panel hole and in both seat backs.
IMPORTANT:
For 1991 vehicles and 1992 vehicles built before VIN NZ101500, the Rear Shelf Panel Front Finish Lace may not be installed or does not stay in
place. Vehicles with this condition may have an exposed metal edge that could fray the Seat Back Tether System straps. If this condition exists,
please reference Technical Information Bulletins 91-T-44 and 92-T-18 for further information.
12.
Place a small amount of Loctite 242(R) Threadlocker, or equivalent, on threads of T-handles.
13.
Install T-handles with attached straps (stitched end) to rear window panel rivet nuts. Ensure T-handles are in the lateral position.
14.
Install T-handles without straps to the seat back rivet nuts. Ensure T-handles are in the lateral position.
