SW1 L4-1.9L SOHC VIN 8 (1996)
3.
Drill 10 mm (3/8 in.) holes through seat back frames at marks on masking tape.
4.
Fold up seat backs.
5.
Using a soft marker, mark locations on rear window panel rail (hollow box section) to line up with holes in seat back. Marks should be in center of
rear window panel rail horizontal surface.
IMPORTANT:
When drilling holes in rear window panel rail, drill through first layer of sheet metal only. Be sure to collect all metal flakes from vehicle interior.
6.
Center-punch, pre-drill 5 mm (3/16 in.) holes, and final-drill 10 mm (3/8 in.) holes at marks on rear window panel rail.
7.
Apply 3M(R) WINDO-WELD Primer (P/N 08643) or equivalent to bare metal edges of hole.
