SW1 L4-1.9L SOHC VIN 8 (1996)
15.
Splice handle BLK wire to other cargo lamp BLK wire using splice sleeves supplied with kit.
16.
Tape and secure all wires to prevent damage due to sharp metal edges.
17.
Connect cargo lamp connector and install cargo lamp housing if removed.
15.
Install 10A BODY fuse in instrument panel fuse block.
Seat Back Tether System Installation
1.
Open decklid and place a piece of masking tape (51 mm [2 in.] minimum width) on both rear seat backs along edge of rear window panel lip.
2.
Fold down seat backs. Place a mark on the masking tape in the middle of each seal back, 40 mm (1.5 in.) down from the top edge of the tape.
IMPORTANT: When drilling holes in seat backs, drill through two layers of plastic seat back frame, but do not push drill through seat cushion fabric.
