SW1 L4-1.9L SOHC VIN 8 (1996)
2.
Using Kent Industries Spray Leak Check Seam Sealer P/N 50087), or equivalent, spray seals with two coats. Refer to manufacturer's
recommended application instructions.)
3.
Verify repair by water testing after sealant has been allowed to dry according to manufacturer's recommended instructions.
4.
After verifying repair, go back and perform steps 5 and 6 under "General Waterleak Testing" in this bulletin to ensure there are no additional
waterleaks at the shock tower or frame rail/hood hinge areas.
Strut Tower Area Waterleak Repair
IMPORTANT:
Right side shown. Left side similar.
1.
If a waterleak is detected in the strut tower area, clean and dry area to be repaired using compressed air and nozzle.
IMPORTANT:
Make sure to pump sealant under the lip of the cowl panel, where it overlaps the strut tower.
2.
Using Kent Industries High Tech Leak Check Seam Sealer (P/N 10105) or equivalent, pump sealant into corner, filling comer with sealant.
