SW1 L4-1.9L SOHC VIN 8 (1996)
a. Install the thermostat and inlet housing into the cylinder block.
b. Install the retaining bolts. Torque to 30 Nm (22 ft. lbs.).
c. Close radiator drain plug and install cylinder block drain plug. Torque to 35 Nm (25 ft. lbs.).
3. Install the lower radiator hose.
IMPORTANT: The vehicle must be level when filling with coolant.
4. Fill the system with coolant. Use only a non-phosphate ethylene glycol-base coolant, mixed according to the manufacturer's directions.
5. Start engine.
6. Fill the cooling system surge tank to the FULL COLD line after the engine has run for two to three minutes.
7. Install pressure cap and check for leaks.
