SW1 L4-1.9L SOHC VIN 8 (1996)
Torque: 25 Nm (19 ft. lbs.)
IMPORTANT: If the pump pulley hub end extending through the pulley is rusty, clean it with a wire brush and apply a thin coat of primer paint
to prevent the pulley from rusting on the hub.
5. Install accessory drive belt.
6. Install right hand side wheel house splash shield and tire,
7. Close radiator drain plug and install cylinder block drain plug. Cylinder block drain plug.
Torque: 35 Nm (26 ft. lbs.)
IMPORTANT: The vehicle must be level when filing with coolant.
8. Remove pressure cap and fill the system with coolant. Use only a non phosphate ethylene glycol-base coolant, mixed according to the
manufacturer's specification.
9. Start engine.
10. Fill the cooling system surge tank to the FULL COLD line after engine has run two to three minutes. Install pressure cap and check for leaks.