SW1 L4-1.9L SOHC VIN 8 (1996)
1. Position A/C compressor clutch coil to A/C compressor in same position as removed.
2. Install three A/C compressor clutch coil screws.
Torque: 5 N.m (44 in-lbs)
3. Install A/C compressor clutch coil electrical connector screw.
IMPORTANT: Make sure A/C compressor clutch coil wire is routed as shown to prevent pinching of A/C compressor clutch coil wire.
4. Place thrust bearing and drive plate installer SA9149AC-3 on installation bolt and insert through center of pulley. Thread installation bolt into end
of A/C compressor shaft and finger tighten.