SW1 L4-1.9L SOHC VIN 8 (1996)
10. Position the puller center tool SA9149AC-2 on the end of the A/C compressor shaft.
11. Install three-jaw puller on A/C compressor pulley. Tighten the center bolt to remove pulley assembly.
IMPORTANT: Make sure to hook the puller jaw behind the pulley.
12. Remove screw holding A/C compressor clutch coil electrical connector to A/C compressor.
IMPORTANT: Make sure to note the position of the A/C compressor clutch coil wire before removal of the A/C compressor clutch coil electrical
connector and clutch coil.
13. Remove three A/C compressor clutch coil screws and remove A/C compressor clutch coil.
IMPORTANT: To enable easier removal of screws. lightly tap on the end of the screwdriver with a plastic hammer.
INSTALLATION