SW1 L4-1.9L SOHC VIN 8 (1996)
identification. (Refer to appropriate model year Automatic Transaxle service manual for diagnostic flow charts.)
IMPORTANT:
Illustration shown is for DOHC engine (RPO LLO); SOHC engine (RPO L24) is similar.
2.
Remove air inlet duct.
2.1
Open clamp at throttle body.
2.2
Disconnect fresh air hose at air duct.
2.3
Remove air cleaner housing cover and air duct.
3.
Remove battery.
4.
Remove battery tray.
5.
Loosen transaxle electrical connector bolt and disconnect transaxle electrical connector.
6.
Disconnect transaxle range switch connectors.
IMPORTANT:
A sewing "seam stripper" is an excellent tool for removing tape from a wire harness. It cuts the tape without damage to the wires under the tape.
7.
Remove electrical tape from wiring harness from transaxle electrical connector to main engine harness (approximately 20-25 cm [8-10 in.]).
