SW1 L4-1.9L SOHC VIN 8 (1996)
Accelerator Cable Routing
2. Route cable through front of dash from the outside in, under the intake manifold, and up between the second and third intake ports.
3. Lower vehicle.
NOTE: Whenever a throttle cable assembly is installed, make sure locking tangs are engaged to front of dash and the seal is properly installed
to prevent water intrusion. Pull on the cable to insure the tangs are engaged.
4. Install cable retainer into front of dash & lower vehicle.
5. Install cable retainer into the support bracket until locking tangs engage.
6. Connect accelerator cable to throttle lever.
