SW1 L4-1.9L SOHC VIN 8 (1996)
I/P Upper Trim Panel Installation
4. Install I/P upper trim pad sound insulator.
NOTE: Make sure to tuck in all flaps.
NOTE: Be sure I/P upper trim panel seal is correctly seated on forward edge before installing upper trim panel (SL/SW only).
5. Install I/P upper trim panel into clips at base of windshield.
NOTE: Be careful when removing or replacing upper trim panel, not to damage VIN plate.
6. Lower I/P upper trim panel, making sure I/P upper trim panel alignment tabs interlock with windshield garnish slots (SL/SW only).
7. Push down at clip locations to secure.
I/P Upper Trin Panel
8. Install I/P upper trim panel screws.
9. Install I/P bolt cap.