SW2 L4-1.9L DOHC VIN 7 (1997)
7. Remove clutch pushrod retainer and remove pushrod from clutch pedal.
8. If replacing clutch pedal assembly:
a. Remove clutch pedal pivot shaft nut.
b. Remove clutch pedal assembly.
9. If replacing pivot bushings:
a. Remove clutch pedal pivot shaft retainer.
b. Remove clutch pedal.
c. Remove clutch pedal bushings.
INSTALLATION
1. If replacing pivot bushings:
a. Install new bushings.
b. Lubricate inside diameter of bushings.
c. Install clutch pedal onto pivot and install retainer.
2. If replacing clutch pedal assembly:
a. Install pedal assembly.
b. Install pivot shaft nut and tighten.
-
Torque: 17 Neon (151 inch lbs.).
3. Grease clutch pedal pushrod pin and install pushrod onto pedal.
4. Install pushrod retainer.
5. Install upper trim panel insulator.