saturn Workshop Repair Guides

Saturn Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 3
background image

7. Clean the TPS pocket of any foreign material.
8. Apply Saturn thermal conductive sealant P/N 22681632 to the TPS pocket.

IMPORTANT:  Use Saturn thermal conductive sealant P/N 22681632 to ensure the TPS functions properly.

9. Install the TPS to the TPS pocket on the compressor.

10. Remove any excess sealant from around the switch.
11. Install the TPS retainer to the compressor.
12. Install the TPS retainer bolt to the compressor.

NOTE:  Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 6 N.m (53 lb in).

13. Install the electrical connector to the clutch coil bracket.
14. Lower the vehicle.

Heating and Air Conditioning > Compressor Thermal Protection Switch <--> [Superheat Switch, HVAC] > Component Information > Service and Repair > Page 8196

< PREV PAGE NEXT PAGE >