tC L4-2.4L (2AZ-FE) (2005)
Adhesive: Part No. 08850-00801 or equivalent
1. Cut off the tip of cartridge nozzle as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time written in the table.
2. Load the sealer gun with the cartridge.
3. Apply adhesive to the back door glass as shown in the illustration.
d. Install the back door glass to the vehicle body.
1. Lightly press the front surface of the back door glass to ensure that the back door glass is securely fit to the vehicle body.
NOTE:
- Check that the spacers are attached to the vehicle body correctly.
- Check that the vehicle body and back door glass have a small gap between them.
2. Hold the back door glass in place securely with protective tape or equivalent until the adhesive hardens.
NOTE: Do not drive the vehicle for the amount of time written in the table.