tC L4-2.4L (2AZ-FE) (2005)
/Page-1173005.png)
When removing the drive cable, be careful NOT to damage the side airbag, wire harness, and other nearby parts.
16.
Repeat step 15 to remove the sliding roof drive cable RH.
17.
Remove the sliding roof cable guide casing.
18.
Remove the sliding roof lift guide LH.
A.
Slide the lift guide forward and remove it.
B.
Disconnect the cable case connector from the lift guide as shown in the illustration.
19.
Repeat step 18 to remove the sliding roof lift guide RH.
20.
Remove the windshield molding outside.
HINT:
^
The roof panel cannot be removed/replaced by itself because the windshield glass and roof panel are built into the molding. First, the
molding must be lifted, and then the roof panel can be replaced.
^
Using a plastic pry tool, lift the top windshield molding from the rear edge. Then, the roof panel can be lifted out.
21.
Remove the sliding roof housing sub-assembly by removing the sixteen (16) nuts and panel.
CAUTION:
When removing the panel, be careful NOT to damage the vehicle. Perform this step with two (2) or more people.
