tC L4-2.4L (2AZ-FE) (2005)
/Page-1176003.png)
F.
Remove the tightening bolt for the drive gear. Remove the drive gear assembly.
2.
Install the drive gear. Installation is the reverse order of removal.
Bolt Tightening Torque: 5.4 +/- 1.5 Nm (55.06 Kgf.cm, 3.98 ft.lbf)
NOTE:
^
Do NOT attempt to fully tighten the bolts and nut the first time.
^
When tightening the bolts for the drive gear assembly, tighten them alternately and gradually.
3.
After replacing the drive gear, initialize the sliding roof system and check that the system functions properly.
To initialize the sliding roof system, refer to TSB No. PD008-05, "Power System Initialization During PDS."
