tC L4-2.4L (2AZ-FE) (2005)
/Page-1162010.png)
2. CLEAN THE WIND DEFLECTOR GLASS
(a) Clean all surfaces of the glass highlighted in the illustration above with isopropyl alcohol to remove any dirt, oil, or grease.
NOTE:
^
DO NOT use brake cleaner!
^
There is a portion of glass underneath the rear section of the metal frame that requires cleaning.
(b) To clean the portion of glass underneath the rear section of the metal frame, use the squeegee to push a cleaner pad soaked with isopropyl alcohol
into the hard to reach area as shown in the illustrations above.
NOTE:
^
DO NOT use brake cleaner!
^
The squeegee and cleaner pads are included in the Protective Laminate Kit.
(c) After cleaning, allow the surface to dry completely, this may take approximately 2 to 5 minutes.
3. APPLY THE PROTECTIVE LAMINATE
