tC L4-2.4L (2AZ-FE) (2005)
(a) Test fit tape pieces No. 1, 2 & 3 to ensure a good fit.
NOTE:
The numbers used in the illustration and in the step above are for reference only; the actual tape pieces DO NOT have numbers on them.
(b) Starting with piece No. 1, peel the backing from the tape and gently lay it into place on the glass. Once the tape is in the proper position, carefully
apply light pressure to remove any wrinkles or air bubbles.
NOTE:
^
If you make a mistake while positioning the tape, remove or adjust it quickly, because in a short time it will become difficult to do so.
^
DO NOT apply any pressure on the tape until it is in the proper position!
(c) When all wrinkles and air bubbles have been removed, carefully reapply pressure to make sure the tape is firmly attached, and its edges fully
applied to the glass.
(d) Repeat the procedure for pieces No. 2 & 3.
NOTE:
A gap between pieces No. 1 & 2 and between pieces No. 1 & 3 is normal.
(e) Test fit tape pieces No.4, 5, 6 and 7 to ensure a good fit.
NOTE:
The numbers used in the illustration and in the step above are for reference only; the actual tape pieces DO NOT have numbers on them.
(f) Starting with piece No.4, peel the larger section of backing from the tape.