scion Workshop Repair Guides

Scion Workshop Service and Repair Manuals

Fuel Pressure Release|Service and Repair|Page 881 > < Idle Speed|Specifications|Page 876
Page 1
background image

Fuel Pressure Release: Service and Repair

FUEL SYSTEM 

PRECAUTION 

NOTE:  When disconnecting the battery terminal, initialize the following system after the terminal is reconnected. 
-

Power window control system

-

Sliding roof system

1. PRECAUTION

a. Before working on the fuel system, disconnect the battery negative terminal.
b. Do not work on the fuel system near fire. Never smoke during the work.
c. Keep rubber and leather parts away from gasoline.

2. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION: 
-

Before removing fuel system parts, take precautions to prevent gasoline spillage.

-

As some pressure remains in the fuel line even after taking precautions to prevent gasoline spillage, use a shop rag to prevent gasoline splashes
when disconnecting the fuel line.

a. Disconnect the battery negative terminal.
b. Remove the rear seat cushion.

c. Remove the butyl tape, then remove the rear service hole cover.
d. Disconnect the fuel pump connector.
e. Connect the battery negative terminal.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 

f.

Start the engine.

g. Turn the ignition switch to OFF after the engine stops.

HINT:  DTC P0171 (system too lean) may be present.

h. Crank the engine again, then check that the engine does not start.
i.

Remove the fuel tank cap, then discharge the pressure in the fuel tank completely.

j.

Disconnect the battery negative terminal.

k. Connect the fuel pump connector.

Fuel Pressure Release|Service and Repair|Page 881 > < Idle Speed|Specifications|Page 876