tC L4-2.4L (2AZ-FE) (2005)
/Page-580001.png)
Evaporative Emission Control Canister: Testing and Inspection
INSPECT CHARCOAL CANISTER ASSEMBLY
a. Visually check the charcoal canister for cracks or damage. If cracks or damage are found, replace the charcoal canister assembly.
b. Check charcoal canister operation.
1. While holding the purge port closed, blow air 1.67 kPa (17.0 gf/sq.cm, 0.24 psi) to the vent port, and check that the the air flows from the air
inlet port.
If the result is not as specified, replace the charcoal canister assembly.
2. While holding the vent port closed, blow air to the air inlet port 1.10 kPa (11.2 gf/sq.cm, 0.16 psi) to the purge port, and check that the air
flows from the purge port.
If the result is not as specified, replace the charcoal canister assembly.
