tC L4-2.4L (2AZ-FE) (2005)
/Page-715001.png)
Pressure Plate: Specifications
CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting from the bolt locating near the knock pin on the top.
Torque ............................................................................................................................................................................. 19 Nm (195 kgf-cm, 14 ft. lbs.)
HINT:
Evenly tighten the bolts by following the order shown in the illustration.
Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.
