tC L4-2.4L (2AZ-FE) (2005)
4. CLEAN VEHICLE BODY
a. Clean and shape the contact surface of the vehicle body.
1. On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
HINT: Leave as much adhesive on the vehicle body as possible.
NOTE: Be careful not to damage the vehicle body.
2. Clean the contact surface of the vehicle body with cleaner.
HINT: Even if all the adhesive has been removed, clean the vehicle body.
5. INSTALL BACK WINDOW GLASS SPACER
a. Apply Primer G to the glass where the spacers will be installed.
HINT: If primer G is applied to an area other than that which is specified, wipe off the primer with white gasoline before it dries.
NOTE:
-
Allow the Primer G to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
-
Do not apply too much Primer G.
b. Install 2 new spacers onto the back door glass as shown in the illustration.