xA L4-1.5L (1NZ-FE) (2006)
/Page-385007.png)
e) Install the chain tensioner with the 2 bolts.
1) While rotating the stopper plate of the chain tensioner upward as shown in the illustration, push in the plunger of the tensioner.
2) While rotating the stopper plate of the tensioner downward, insert a 2.5 mm (0.098 inch) diameter bar into the holes of the stopper plate
and the tensioner to hold the stopper plate.
3) Install the chain tensioner with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
4) Remove the bar from the chain tensioner.
f) Check the tension between the intake and exhaust camshaft timing sprockets.
2. INSTALL OIL PUMP SEAL
3. INSTALL TIMING CHAIN COVER
4. INSTALL WATER PUMP
5. INSTALL ENGINE MOUNTING BRACKET RH
a) Install the mounting bracket RH with the 4 bolts.
Torque: 55 Nm (561 kgf-cm, 41 ft. lbs.)
6. INSTALL ENGINE MOUNTING INSULATOR RH
a) Install the mounting insulator with the 5 bolts and nut.
Torque: 45 Nm (459 kgf-cm, 33 ft. lbs.) for bolt A
52 Nm (530 kgf-cm, 38 ft. lbs.) for bolt B and nut
b) Install the liquid tube with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 7 ft. lbs.) for bolt C
7. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
