xA L4-1.5L (1NZ-FE) (2006)
/Page-385006.png)
24. REMOVE CHAIN TENSIONER SLIPPER
a) Remove the bolt and tensioner slipper.
25. REMOVE NO. 1 CHAIN VIBRATION DAMPER
a) Remove the 2 bolts and chain vibration damper.
26. REMOVE CHAIN
INSTALLATION
1. INSTALL CHAIN
a) Set the position of the No. 1 cylinder to 20° ATDC.
NOTICE: To prevent the pistons from hitting against valves, these procedures must be performed in this order.
1) Set the crankshaft between 40 to 140° ATDC.
2) Set the cams of the intake and exhaust timing sprockets to 20° ATDC.
3) Reset the crankshaft to 20° ATDC.
b) Install the chain vibration damper with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
c) Align the timing marks of the camshaft timing sprocket, camshaft timing gear and crankshaft timing sprocket with each mark plate (colored in
yellow) of the timing chain.
HINT: To prevent the exhaust camshaft from springing back, turn it using a wrench and set it at the mark on the chain.
d) Install the chain tensioner slipper with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
