xA L4-1.5L (1NZ-FE) (2006)
c. Using a screwdriver, detach the claw of the cable clamp and disconnect the defroster damper control cable.
NOTE:
-
Be careful not to bend the cable wire.
-
If the cable wire bends, the defroster damper control cable operation may be affected.
HINT: Tape the screwdriver tip before use.
d. Using a screwdriver, detach the claw of the cable clamp and disconnect the air mix damper control cable.
NOTE:
-
Be careful not to bend the cable wire.
-
If the cable wire bends, the air mix damper control cable operation may be affected.
HINT: Tape the screwdriver tip before use.
e. Remove the heater control and accessory assembly.
7. REMOVE AIR INLET DAMPER CONTROL LEVER
a. Detach the claw, and remove the air inlet damper control lever.