xA L4-1.5L (1NZ-FE) (2006)
Housing Assembly HVAC: Service and Repair
Removal and Installation
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
3. DISCONNECT SUCTION HOSE SUB-ASSEMBLY
a. Install SST to the piping clamp.
SST 09870-00015
NOTE: Be careful not to deform the hose when pushing down on SST.
HINT: Confirm the direction of the piping clamp claw and SST by referring to the illustration shown on the caution label.
b. Push down on SST and detach the clamp lock.
NOTE: Be careful not to deform the hose when pushing down on SST.
c. Pull SST slightly, push the release lever, and then remove the piping clamp with SST.
d. Remove the bolt and disconnect the bracket.