xA L4-1.5L (1NZ-FE) (2006)
1. Connect the air inlet line tube to the canister (leak detection pump).
2. Connect the vent line tube to the canister.
3. Connect the purge line hose.
HINT: Install the hose to the canister, and then attach the retainer.
c. Connect the connector and attach the 2 clamps.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.