xA L4-1.5L (1NZ-FE) (2006)
c. Using snap ring pliers, remove the snap ring and plate washer.
d. Remove the starter armature from the commutator end frame.
4. REMOVE STARTER ARMATURE PLATE
a. Remove the plate from the starter yoke.
5. REMOVE PLANET GEAR
a. Remove the 3 planet gears.
6. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
a. Remove the starter center bearing clutch with drive lever set pin from the starter drive housing.
b. Remove the drive lever set pin from the starter center bearing clutch.
REASSEMBLY
1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
a. Install the drive lever set pin onto the starter center bearing clutch.