xA L4-1.5L (1NZ-FE) (2006)
b. Install the starter center bearing clutch with drive lever set pin to the starter drive housing.
2. INSTALL PLANET GEAR
a. Apply grease to the planet gears and planet shaft pins.
b. Install the 3 planet gears.
3. INSTALL STARTER ARMATURE PLATE
a. Insert the starter armature plate into the starter yoke.
b. Align the cutout of the plate with the inside protrusion of the starter yoke, and install the plate.
4. INSTALL STARTER ARMATURE ASSEMBLY
a. Apply grease to the washer plate and armature shaft.
b. Install the armature shaft onto the starter commutator end frame.
c. Using snap ring pliers, install the plate washer and snap ring.
d. Using a vernier caliper, measure the snap ring length.