xA L4-1.5L (1NZ-FE) (2006)
a. Remove the bolt and 2 nuts.
b. Support the crossmember with the jack.
c. Remove the 4 bolts and disconnect the crossmember.
12. REMOVE FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH
a. Remove the 2 bolts, nut and lower arm.
NOTICE: Do not turn the nut.
INSPECTION
1. INSPECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH
a. As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.
b. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.
HINT: A bolt without a torque specification is shown in the standard bolt chart.
INSTALLATION