xB L4-2.4L (2AZ-FE) (2009)
(a) Check the angle of inclination required to lock the retractor.
(1) Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any
direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
NOTICE: Do not disassemble the retractor.
If the operation is not as specified, replace the front seat outer belt.
(b) Hook the lower stay of the retractor onto the 2 body hooks and provisionally install the retractor with the 2 bolts.
(c) Tighten bolt A and then bolt B.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf) for bolt A
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf) for bolt B
(d) Install the through anchor with the bolt.
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)
(e) Check that the ELR locks.
NOTICE: Perform the check with the front seat outer belt installed.
(1) With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the front seat outer belt.