xB L4-2.4L (2AZ-FE) (2009)
9. SEPARATE FRONT SPEED SENSOR LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
10. SEPARATE FRONT SPEED SENSOR RH
HINT: Use the same procedure as for the LH side.
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Front Shock Absorber/Removal
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Use the same procedure as for the LH side.
13. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Removal
14. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: Use the same procedure as for the LH side.
15. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
16. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Use the same procedure as for the LH side.
17. SEPARATE FRONT AXLE ASSEMBLY LH
(a) Put matchmarks on the drive shaft and axle hub.
NOTICE: Do not punch the marks.
(b) Using a plastic-faced hammer, disconnect the steering knuckle with axle hub.
NOTICE:
-
Do not push the steering knuckle with axle hub further out of the vehicle than is necessary.
-
Do not excessively push out the drive shaft from the axle.
-
Do not damage the oil seal, drive shaft boot or speed sensor rotor.
18. SEPARATE FRONT AXLE ASSEMBLY RH
HINT: Use the same procedure as for the LH side.
19. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(a) Using SST, remove the front drive shaft.
SST: 09520-01010
SST: 09520-24010
09520-32040
NOTICE:
-
Be careful not to damage the transaxle case oil seal, inboard joint boot and drive shaft dust cover.
-
Be careful not to drop the drive shaft.
20. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH